Plug for Prusa - Prusament filament spool reduction
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.86 – €2.28 net (excluding VAT)
For file: spunt - Prusa - v1 _0.4n_0.3mm_PLA_MK4IS_1h15m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.07 excluding VAT (range midpoint).
- Weight reported by the author
- 43 g
- Print time reported by the author
- 1.25 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Reduction into Prusament filament spool for positioning the guide bearing - Placement of the spool on the guide rod.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 17
- Makes
- 1
- Views
- 129
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
For better unwinding of the filament, I constructed a holder that basically uses a 8 mm guide rod on which the spools are placed.
Since there is usually a rather large hole in the spools, I decided to create this reducer, a plug.
This particular reduction, the plug, is adapted to the Prusament coil - where the pin guide is also prepared.
The actual reduction then has a recess for a fixed location of the bearing.
Used bearing:
2 reducers and 2 bearings are needed to place on the rod
note:
The reduction on the photos are printed as:
- 0,4 nozzle
- PLA material
- first layer: 0,3 mm, 3 perimeters
- gyroid infil
- octagram spiral first and last layer