1 / 14
Combinable Raspberry Pi 4 snapfit case - easy to add the Pi
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed a easy to add the RaspberryPi version with a snap fit case. Each Top can be combined with each bottom part.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 385
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (9)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (1)Kolekcje (10)Powiązane
I designed another RaspberryPi Case, because I was not happy with what I found. I designed this one to add the RaspberryPi easily without harming it.
In many cases I found, I have to choose violence to bring it in. Here I designed the holding pins upside down, so you can easily add the raspberry without any pressure.
Each top part can be combined with each bottom part.
Please post a make any comments are welcome.
Print instructions
Printed with PETG Prusament
0.20 mm layer height
Support for the SD-Card slot and the side openings on the bottom part
Update
- Added a version where the HDMI ports are bigger, due to some of you had issues fitting an HDMI cable (09.05.2024)
- Added a version for the Prusa Enclosure (10.05.2024)
- BoM
- 1 M3 heat-set insert. I used from Ruthex M3x5.7 (any other will to, if not longer than 5.7mm and a diameter of 4mm)
- 1 M3 6mm screw for the original Prusa Enclosure (you can choose what suits best)
- BoM
- Added a hexagon design top and bottom part (10.05.2024)