1 / 3
Shop Vac 2-1/2 in Crevice Nozzle
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Could not find this style of OEM nozzle for my 16 gallon/60 liter RIDGID Wet/Dry Shop Vacuum.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 87
- Wydruki
- 0
- Wyświetlenia
- 533
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
I designed this crevice nozzle to specifically fit my RIDGID shop vacuum (model WD16400) as I could not find an exact replacement. The build is exactly 250mm tall - the limit of my printer. Please be aware of this when considering this print!
Print Information
- Printed with a small brim, I thought this might be a good idea to give a bit extra bed adhesion given the height. I really didn't want to see my print fail at the very end.
- Recommended using a lower layer height of 0.2mm for higher strength and a reasonably high infill of 50% to give this tool the best chance of living a long and sucky life!
- This part was printed in PLA though it would likely be that much better in PETG or ABS.
Post-print Fitment
- I found the fitment after printing was a bit tight. I think this may vary slightly from printer to printer and filament to filament. I am going to sand down the inside just a little bit to ensure the end seats to the lock.