Hashi-Oki-Mugen / infinite chopstick bank (Spiral vase print)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My take on a chopstick bank (hashi-oki) - I really love spiral vase mode ;) Prints damn quick and is quite rigid.
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 83
- Wydruki
- 5
- Wyświetlenia
- 681
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
My take on a chopstick bank (hashi-oki) - I really love spiral vase mode ;)
Prints damn quick and is quite rigid.
Printing instructions
This is not meant to be printed as a solid object!
- use regular draft print profile (0.3 layers)
- enable “Spiral vase” mode
- set line width to 1mm (yes, with your 0.4 nozzle)
- remove bottom layers
- remove skirt
Even though the thin walls, due to the narrower inner part the print will be very rigid anyways.
The pictured print even was done with reduced minimum layer time - the fastest I could get was around 12 minutes before cooling wasn't sufficient anymore.
Alternative printing instructions
If you dislike wide extrusions, you may also go for
- Standard quality profile
- 3-4 perimeters
- no top layers
- no bottom layers
- no infill
for 40-48min print time.
… Draft profile without any modifications would give you a solid object in 44min.