ElectroCookie Control Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A box for mounting ElectoCookie based electronics.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 57
- Wydruki
- 0
- Wyświetlenia
- 353
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Mount and protect your electronics in this box.
This box was designed to hold a standard ElectroCookie solderable breadboard firmly in place. The design will allow you to mount it on a flat surface or a 30mm to 40mm pole with the provided mounting brackets.
This is part of my DIY weather station.
Print Instructions
Print with your preferred material for the environment it will be mounted.
Fill should be at least 15% but greater fills may be needed for more rugged use.
Support material is only needed for the wire access hole in the box as long as the brackets are printed on their sides.
Hardware
- 2 x M3 6mm Hex Head Screws
- 2 X M5 40mm Pan Head Screws
- 2x M5 Nuts
Seal wire hole and lid to the box with weatherproof silicone caulk if needed.