Assault Bike phone and tablet mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This mount accepts most push-in suspension arms to hold tablets and phones in front of the user.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 16
- Wydruki
- 1
- Wyświetlenia
- 465
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Indoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This mount fits the assault bike neck and allows most simple push-in suspension arms to be used, similar to this type. Much nicer having your tablet or phone in front of your face, rather than hanging your head.
It should be printed in PLA at least, with dense infill and 5 perimeters minimum for strength. V1 was printed with default settings, less infill, and snapped like a potato chip. The attached project file is the second version I am using and it is solid. Supports on build plate only. They remove easy as is in the file.
I recommend one layer of electrical tape or duct tape around the neck to provide some grip for the mount. It also helped fit snugly once tightened. Use M3 hardware to connect. Don't worry about the support scuz left over inside, your tape layer will like it sinking in for good grip.