1 / 1
Electric guitar neck shim assortment for Fender-style necks — zdjęcie 1

Electric guitar neck shim assortment for Fender-style necks

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A set of shims that fit standard Fender electric guitar neck bolt patterns. It has various heights and inclinations.

Ocena
5 / 5
Polubienia
16
Pobrania
242
Wydruki
0
Wyświetlenia
910
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Music
Licencja
Creative Commons — Attribution

Sometimes your guitar's bridge is too high for your neck.  This impacts the action of the guitar and can make it really difficult to play or to get the action you want.  The quick fix has been to use stacks of old credit cards with holes drilled through them.  The proper fix has been to buy wooden shims at specific heights and inclinations.  These printable shims remove the need for pricey parts or Grateful Dead-era roadie tricks.  

If you're building a DIY guitar from a kit and it has a Gibson bridge and Fender style bolt-on neck, these shims will REALLY help.  Gibson bridges' lowest points are higher than Fender bridges' lowest points, which mean you'd have some pretty high action at the 12th and higher fret.  Putting a shim in the neck pocket can close the gap a little.  

I'd recommend using calipers to measure the distance between the top of your highest fret - 21st, 22nd, whichever - and the bottom of the low E string.  Print the shim that comes in exactly at that distance - yes, it will be touching the string, but then it's easier to raise the action and clear it.  This may also change neck relief, but that's what the angle of the shim helps with.

Having a 1 or 2 degree tilt can sometimes help compensate for neck relief if your truss rod is already in heavy use.  Turning it too much can cause stress or damage.  If the neck is a degree or two higher at the pocket, you'll change the need for neck relief in the first place and might be able to loosen your truss rod a bit as you adjust the action.  

The shims are squared at the bottom.  If you're putting them on a Telecaster neck it should be an easy enough fit.  If it's a Strat, you may need to sand a bit to fit.  The pocket end of the neck does not necessarily have to be flush in the neck pocket, as long as it's securely bolted in.  

You can scale the height in your slicer if you want to go higher up.  If you do, bear in mind that your stock neck screws may not reach all the way into your neck.  You'd need to use #8 screws, probably 1 ½" or 1 ¾", to clear the gap.  Go easy and slow, you do NOT want to screw through your fretboard.  Install with the angle side facing into your guitar body - any pointed tops of angles should flatten out once the neck is bolted in.

Highly recommend printing at 100% infill.  I haven't noticed a performance or functional difference between ABS or PLA.  

I am not the world's greatest CAD designer - these came out of Tinkercad.  Feel free to improve, I'm sure it will be useful. 

Tagi