GT Omega Wheelstand Shifter Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Shifter mount for the GT Omega Wheelstand
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 113
- Wydruki
- 0
- Wyświetlenia
- 812
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial
A Shifter mount for the GT Omega Wheelstand, designed for the Thrustmaster TH8 but should also work for other shifters with table clamps, alternatively the model can be edited to punch some holes in case it should be bolted on.
Disclaimer
This Model is a WIP and made by a complete noob, i made it as more of an experiment/exercise in 3d modelling, please don't use this and expect it to be a worthy substitute to the official metal counterpart, it may snap and break your shifter, i am NOT responsible for broken hardware, dreams or bones!
Designed this in about 3 hours after looking at GT Omegas website and seeing that the shifter mount costs 40 bucks, since i wanted to get into 3d modelling anyhow this was a perfect experiment.
Print Guide
You will need 2 M8x45 bolts and nuts to secure the shifter mount to the Wheelstand, i included some i quickly threw together in Mike Thompson's Screw Library which seem to do the job but are prone to snapping, make sure to print these horizontally with supports for strength, neither the wheelstand nor my model have threaded holes so was long as they are large (and long enough! at least 40mm) they should work fine.
When printing this i would HIGHLY recommend using a sturdy material, i printed it in PLA and it has not snapped after a quick 15 minute session, but i would not trust this for very long, if you print it in something else, please let me know!
It's intended to be printed in the orientation the STL comes in, using conventional supports.
To test fit i recommend printing it oriented with the back side (towards the wheelstand) down with lightning infill and 2 walls, this wont require supports and will not support the weight of the shifter during use, but give a decent idea on if it works for you without wasting 100g of filament.
Print Settings
Material: PLA+ (but i recommend something that is sturdier, PETG or ABS may work better!)
Layer Height: 0.2-0.24, higher may be stronger!
Walls/Perimeters: >6 (more is better!)
Don't forget to change the Top/Bottom shell layers as well!
Infill: 20% Gyroid or better
Supports: Yes, Normal.
Brims: enabled, i noticed the print starting to flex off the bed without brims enabled.