17mm lugnut cover with removal tool

Want to cover up your weathered lugnuts? I wanted to, so I've designed my own covers, with an additional, helpful little removal tool.

Main features:

• 17mm lugnut cover;
• Subtle markings/etches on top (intended to help with orientation of the removal tool, visible on the PrusaSlicer screenshot);
• Compact sized (35mm x 25mm), keychain compatible removal tool.

Usage:

To apply the covers, simply push them onto the lugnuts on your vehicle all the way until the inside of the cover hits the top of the lugnut.

To remove the covers, orient the remover with the markings on top of the covers, and push the removal tool all the way until the claws click in place (moderate force should be required to make the removal tool's claw open up). With the remover clicked into place, pull off the cover. The remover is relatively thinner than the removal slots on the covers (this should help with clicking in the remover), which may cause the cover to fall off when removed from the lugnut. It is recommended to avoid parking on storm drain covers/grates while removing the covers to avoid losing them.

Recommended print settings:

• I've printed them with PLA (no problems so far), but recommend ASA for outdoor use;
• Standard temperature settings for your printer configuration and filament type;
• 0.1mm layer height for properly visible removal markings on top;
• Concentric top and bottom infill pattern (to achieve the design visible on the PrusaSlicer screenshot);
• No brim or supports required.

I've uploaded the .bgcodes with Mini+ and PLA presets and 0.1mm layer height for 8 lugnut covers (2h40m-ish print time) and a remover tool 15m-ish print time) for your convenience. Printing a complete set for 4-lugnut wheels in a single session (16 covers + remover) should take about 5h35m.