Magnetic Air Vent Redirection Device
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
I have an air vent that is pointing directly at my 3D printer. The cold air shock was causing some warping on larger prints. This allows me to keep the air blowing in the room, just pushing it to the other side which appears to be helping. Magnetic mount allows me to remove it at anytime.
I also printed 2 more to keep the air from blowing directly on my bed at night, the wife loves it.
Print Settings
0.2mm layer height
8% infill (Maybe drop down if you know your bridging is good)
Add a pause just before the last 2 layers to insert the magnets
I am using 16 - 6x2mm magnets (Holes are 6.2mm x 2.2mm).
No supports needed
Brim recommended
If you notice the hole size difference in the photos, my first print had 2mm wide slots, I adjusted to 5mm slots. I thought it looked a little better but did not notice a functional difference.