1 / 4
Anker 347 Cage for 15mm Rail camera setup
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
I needed something as a stand in until I upgrade to a V mount battery setup, so I made a cage that would hang from a set of 15mm rails.
When I printed it, I printed it laying down with the holes facing up. This caused a problem getting the supports out of the bottom holes, and I had to bore them out a little. I would look at printing it laying down, but with the holes on the side.
The rails will block one of the USB C ports, but I'm only using one, so I did not go back to re-work this. Just a heads up.