1 / 11
Vesa 75x75 Monitor Mount for Dremel 220 Workstation | Vesa 75x75 Monitorhalter für Dremel 220 Bohrständer — zdjęcie 1
1 / 11

Vesa 75x75 Monitor Mount for Dremel 220 Workstation | Vesa 75x75 Monitorhalter für Dremel 220 Bohrständer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Vesa 75x75 monitor mount for a Dremel 220 workstation. | Vesa 75x75 Monitorhalter für einen Dremel 220 Bohrständer

Ocena
0 / 5
Polubienia
5
Pobrania
27
Wydruki
0
Wyświetlenia
463
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a Vesa 75x75mm monitor mount that can be hooked into the tool holder ("crows nest") of a Dremel 220 workstation. Use short M3x6 screws with a maximum head size of 5.5mm to mount the monitor. Depending on the weight of the monitor, a cable tie under the tool holder is recommended to prevent it from sliding down.
Print it in STL orientation with 3-4 outer and 4-5 upper/lower layers, with minimal support and 15% infill.

— I would be very happy if you have as much fun with the things as I do. — 

 If you like Buy Me a Coffee :-) Thank you very much!


--- German description ---

Das ist eine Vesa 75x75mm Monitorhalterung, die in den Werkzeughalter eines Dremel 220 Bohrständers eingehakt werden kann. Benutzt zur Monitormontage kurze M3x6 Schrauben mit maximal 5,5mm Kopfgröße. Je nach Gewicht des Monitors empfiehlt sich ein Kabelbinder unter dem Werkzeughalter, so dass er nicht herunterrutscht.
Druckt das Teil in STL-Ausrichtung mit 3-4 Außen- und 4-5 oberen/unteren Schichten, mit Support und 15% Infill.

Tagi