Vesa 75x75 Monitor Mount for Dremel 220 Workstation | Vesa 75x75 Monitorhalter für Dremel 220 Bohrständer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Vesa 75x75 monitor mount for a Dremel 220 workstation. | Vesa 75x75 Monitorhalter für einen Dremel 220 Bohrständer
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 27
- Makes
- 0
- Views
- 463
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a Vesa 75x75mm monitor mount that can be hooked into the tool holder ("crows nest") of a Dremel 220 workstation. Use short M3x6 screws with a maximum head size of 5.5mm to mount the monitor. Depending on the weight of the monitor, a cable tie under the tool holder is recommended to prevent it from sliding down.
Print it in STL orientation with 3-4 outer and 4-5 upper/lower layers, with minimal support and 15% infill.
— I would be very happy if you have as much fun with the things as I do. —
If you like Buy Me a Coffee :-) Thank you very much!
--- German description ---
Das ist eine Vesa 75x75mm Monitorhalterung, die in den Werkzeughalter eines Dremel 220 Bohrständers eingehakt werden kann. Benutzt zur Monitormontage kurze M3x6 Schrauben mit maximal 5,5mm Kopfgröße. Je nach Gewicht des Monitors empfiehlt sich ein Kabelbinder unter dem Werkzeughalter, so dass er nicht herunterrutscht.
Druckt das Teil in STL-Ausrichtung mit 3-4 Außen- und 4-5 oberen/unteren Schichten, mit Support und 15% Infill.