Archetype Flat Orbiter Mount v2 (Blackbird, Mjolnir, Atrocity)

Updated to v2 for various duct compatibility and issues I encountered over the past few months.

1. Creep problem
After using it for several months, the problem with v1 was that the layer direction was not good for pressure distribution and the outer wall was too thin, which led to the creep problem.
To solve this, I increased the outer wall thickness to 1.2mm so that it could be printed with 3 walls (based on 0.4 nozzle).

1.1 Improved model and printing direction
Previously, I printed it lying on the floor, but I found out that it was not good for pressure distribution.
I recommend printing it standing up!

I wanted to minimize the supporters for the with_can version, but I couldn't help it🥲

2. Archetype duct compatibility
The model that was previously only compatible with the blackbird small size has been modified into 3 forms:
Blackbird (Small, Medium, Forbidden (Long)) compatible
Mjolnir (Medium, Long) compatible
Universal (Blackbird (All), Mjolnir (All), Atrocity) compatible
I personally confirmed that there were no problems with the Blackbird and Mjolnir mounting tests, but I only confirmed the Universal design in CAD

It's hard for me to use everything by myself. Please try it out and share your experiences or problems with makes or comments!🫡

----------------------------------- v1 --------------------------------------

The Orbiter was modified to be mounted on a flat mount.
Unlike the original mount, the m3 square nut is not used, allowing archetype tool head assembly using only heat set inserts.
I have been using the heat set insert method for over a month and have had no problems at all.

It cannot be used on Breakneck!!
Currently I've only tested the Blackbird.

The standoff of the ebb board uses 20mm.
It is very firmly fixed with three-point support along with an additional hole for the orbiter mount.

The ebb36 mount refers to djos_1475's aluminum mount design.

The explanation may be strange due to the use of a translator.🥲