1 / 7

Tippmann TMC to TIP 98 Magazine SIDE Adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

UntangleWORKS

@UntangleWORKS

This one have not been printed and tested but this one should work without any problem. if you like to be the cover…

Ocena: 5 / 5
Polubienia: 5
Pobrania: 47
Wydruki: 1
Wyświetlenia: 459
Oceny: 1

Aktualizacja u źródła: 12 kwi 2022

Informacje o modelu

Źródło: Printables
Kategoria: Other Sports
Licencja: Creative Commons — Attribution

Szczegóły Pliki (4)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (6)

This one have not been printed and tested but this one should work without any problem.

if you like to be the cover photo of this one. then you can send a picture of your marker with the adapter to me thanks.

bitchute movie link: https://www.bitchute.com/video/NZlRmetBmjad/

link to the Installation video of the T15 and TMC magfed adapter

Update**_
23-05-2020 TMC MW MR V4 added there was a error in part V3. this error was not noticeable in cura. I mean I have printed them with out a problems like 7 times. but I'm now a better skilled in freecad so it was a easy fix
update 23 06 2020___**
new mag release button wide added.

Print Settings

Supports:

Yes

Infill:
40%
Post-Printing

it can be a smart thing to melt in a iron or copper wire in the part shown in the picture. or print that section with a higher infill. at first was I surprised that it looked that is was not needed. but I had a failure on my second print so. keep that weak spot in mind.

for use of the 2 pins, just use 2x m3 bolts with a length of 12mm.
and of course 1 spring and 2 pins are needed to make the mag catch work.

Category: Sport & Outdoors

Tagi

adapter thingiverse paintball magfed tippmann tippmanntmc tippmann98

Tippmann TMC to TIP 98 Magazine SIDE Adapter

Informacje o modelu

Print Settings

Infill: 40% Post-Printing

Tagi

Infill:
40%
Post-Printing