Replacement feet for IKEA Ektorp for passage with vacuum cleaner robot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Couch legs leave space for dirt but not for robots. Replacement legs solve this.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 552
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
CHALLENGE & IDEA
The couch legs unfortunately leave just enough space for an incredible amount of dirt (especially if you own a dog or other hair-shedding pets) to accumulate, but at the same time not enough room for the robot vacuum cleaner (in my case a Roborock S7) to get under the couch. The replacement legs solve this problem.
The height of the replacement legs is 100 mm. If you need a different height, don't hesitate to contact me!
PRINTING INSTRUCTIONS
I printed it with PETG on the open side without support material.
Further settings:
- 20% Infill
- 0.4mm Nozzle
- 0.2mm Layer hight
- 7 Perimeters
- 9 Bottom Layers
- 9 Top Layers
Print Time on Prusa MK3s about 14 hours - each piece.
MATERIALS
- M8 Threaded rod (110mm for the 100mm leg-Version)
- IKEA Ektorp to mount the Replacement Legs & relaxed time on the sofa
- A whirlwind pooch (Frankie ❤) that leaves piles of hair and assortments of dirt under your Ektorp
MOUNTING INSTRUCTIONS
- Print that wonderful leg
- Measure your M8 Threaded rod and cut (110mm)
- Clean the Threaded rod (oil & silicone!)
- Add a tiny quantity of glue (like UHU Instant Adhesive) to the screw's thread
- Screw the threaded rod into your foot until it stops. Be careful, the threading is quite strong, don't damage your bottom layer - only turn until the stop.
- Wait! Relax! Allow time for the glue to harden
- Now screw your first foot under the couch - does everything fit? Then print the additional feet!
- Install the remaining feet.
- Make some photos of your print and post them on Printables! ❤ Thanks!
- Lay back on the couch, fire up your robot vacuum cleaner, and watch the little hero go to work! 🎉
VERSION HISTORY
20240518 Added picture of mounted feet
20240516 Added pictures while printing, finished print
20240515 Initial Version
QUESTIONS?
Do you have any questions about this model, a suggestion or do you need an adjustment? Feel free to write to me here via the Printables Messenger (chat). I look forward to hearing from you.