Helical Gear, 45 degrees, 16t, Lego compatible
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
45 degrees helical gear, Lego compatible
- Ocena
- 0 / 5
- Polubienia
- 24
- Pobrania
- 145
- Wydruki
- 0
- Wyświetlenia
- 597
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Engineering
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Imported from Thingiverse. Original upload was 04.11.2018 (dd.mm.yyyy)
Consider to follow if you like what I do.
Helical gear for Lego.
These are 45 degrees.
You have to make 2 of the same gear to make it work. No mirroring needed.
Resin printers are better than FDM to make the gears smooth. FDM will work but you have to do the instruction below
Note this if you are using a FDM printer: You have to wear down the gears a bit before use in a vehicle/creation.
Build something like in the picture connect a motor to the smallest gear and let it run for 10 minutes. After that. Connect the motor to the bigger gear and let it run for some time until its smooth.
Print with 0.1 or lower.