Helical Gear, 45 degrees, 16t, Lego compatible
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
45 degrees helical gear, Lego compatible
- Rating
- 0 / 5
- Likes
- 24
- Downloads
- 145
- Makes
- 0
- Views
- 597
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Engineering
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Imported from Thingiverse. Original upload was 04.11.2018 (dd.mm.yyyy)
Consider to follow if you like what I do.
Helical gear for Lego.
These are 45 degrees.
You have to make 2 of the same gear to make it work. No mirroring needed.
Resin printers are better than FDM to make the gears smooth. FDM will work but you have to do the instruction below
Note this if you are using a FDM printer: You have to wear down the gears a bit before use in a vehicle/creation.
Build something like in the picture connect a motor to the smallest gear and let it run for 10 minutes. After that. Connect the motor to the bigger gear and let it run for some time until its smooth.
Print with 0.1 or lower.