1 / 4
Samsung TV and Sound Bar Remote Holder — zdjęcie 1
1 / 4

Samsung TV and Sound Bar Remote Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The model has a maximum TV remote width of 45mm and 49mm for the soundbar. PLA 15% infill support enforcers only

Ocena
0 / 5
Polubienia
4
Pobrania
55
Wydruki
0
Wyświetlenia
305
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Thank you for checking out my remote holder. This is the first ever model created as I'm new in 3D printing and CAD apps. 

The model has a maximum TV remote width of 45mm and 49mm for the soundbar remote. If your remote measures up to the maximum width specified above might not easily fit as my TV remote measures 43mm and the soundbar remote 47 leaving a very small space to wiggle. 

Photos show the model printed in Prusament Galaxy Black PLA with below printer settings:

  • 0.10mm layer height
  • 15% adaptive cubic
  • no brims or supports

There are some groves on the bottom of each remote holder with the purpose of catching the tip of the remote, holding it into a better position. 

In my original print, the front wall was too small and it was struggling the keep the remote in place. I've now corrected this by increasing the height of the wall from 4mm to 10mm. 

A big thank you to everyone that downloads my model! It would make my day if you upload your make! :D

Tagi