Complete Rosary Parts (beads, center piece, and cross)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rosary beads, cross, and center piece
- Ocena
- 0 / 5
- Polubienia
- 67
- Pobrania
- 515
- Wydruki
- 0
- Wyświetlenia
- 2480
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution
I made this complete set of beads, a center piece, and a cross (actually Aleks89's design https://www.printables.com/model/434642-orthodox-cross-keychain). I used both PLA+ (black) and PETG (clear) and they both came out very strong at the settings below.
Print settings:
.2mm layer height
15% infill
no support AND NO BRIMS (brims make beads look ugly)
I recommend printing at a moderate speed. I slowed my Bambu Lab A1 settings down by 50% to ensure that the beads stayed in place with no brims and that the walls were high quality. This print should still only take about 2 hours with those settings.
If possible use a scarf joint seam to improve the look of the beads. I used stock Bambu Studio scarf seam settings.
The .3mf file has 60 Hail Mary beads and 10 Our Father beads just incase any come out ugly.
I used #36 rosary twine off of Amazon which has a diameter of 1.3mm. The beads have a diameter of 1.5mm so they have plenty of room. Here is a link to where you can find it.
Happy printing!
