1 / 1
Creality K1 Carriage Shroud, K1C Cooling Head — zdjęcie 1

Creality K1 Carriage Shroud, K1C Cooling Head

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Creality K1 Carriage Housing, K1C Cooling Head, X-Axis Linear Bushing Adjustment

Ocena
5 / 5
Polubienia
26
Pobrania
102
Wydruki
2
Wyświetlenia
2795
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

https://youtube.com/shorts/3lEQP8yHcAc?si=8w0SoceSE24X2NPT

 

Всем англоговорящим мое извините за плохой язык, я из Морковии, мы тут говорить на русский.

UPDATE! New mod fun duct, Last Mod Fan Duct.

Do not bear any responsibility for your actions with the printer, please read the description carefully before use!

The modification is not for housewives; if you don’t understand what to do, then don’t even try to install it. Anyone in the topic can write to me in private messages to clarify details, basic information is not for public access.

Carriage casing with fan channel and linear bronze bushing pressure adjustment system. Cool your ardor, this mod is in development, being tested and upgraded. At the moment, the stable version eliminates most of the jambs from the factory, almost completely removes resonance, but in order to completely remove it you need to completely disassemble the portal and sort out the carriages, put washers under the spools, fix the bottom guide after assembly (my method is radical, I drilled the X-axis carriages and installed the bushings in the lower shaft, secured them on the reverse side with screws) these actions will void your warranty if there is one, so it is better to use a liquid retainer.

There are also a lot of rattling components in the printer (power supply fan, install washers through the TPU, make noise from the bottom of the case and strengthen all the wires.) The K1 series is crap, but after modifications it doesn’t rattle like a refrigerator.

You can try to use original springs, but it’s better to choose a softer one, and in general, for full control you need root access, the best option is Guppy screen, which allows you to take measurements and fully control the printer.

Select the fan speed of the model, the flow varies greatly. I print mostly petg, 30% is enough for me in the main mode.

 

Tagi