Gridfinity Endmill / Router Bit Holder for 1/4" Shank in Vase Mode
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Organize your 1/4 inch shank endmills for your desktop CNC with this gridfinity endmill holder. Vase mode for speed!
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 489
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
This part is made in two pieces that nest. Print each piece in vase mode (0.4mm nozzle, is what I used), then slide them easily together. And you can store up to six endmills, 1/4in. shank, neatly in one #gridfinity square.
The trick is printing the base/outside piece right side up, and printing the insert/endmill holder upside-down. Set your slicer for vase mode, and print them one at a time with a 0.4mm nozzle, and they should slide easily together.
The trick to designing such a part is making sure that there is only one path around the whole thing, that's why the side lines are cut in. Also, at the bottom of each hole is a slant which allows for minimal stringing as the hole tapers to a single straight edge.
Vase mode make this whole thing print in about 70min. on a Prusa MK3S+.