1 / 4
Balljointed Magsafe Monitor Holder — zdjęcie 1
1 / 4

Balljointed Magsafe Monitor Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Holder for Magsafe charger that is mounted to the back of your monitor using the VESA100 mounting holes.

Ocena
4 / 5
Polubienia
100
Pobrania
186
Wydruki
1
Wyświetlenia
3094
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial

Holder for Magsafe charger that is mounted to the back of your monitor using the VESA100 mounting holes using two M4x25mm bolts. The backplate of my monitor arm is 3mm thick so you might want to use longer or shorter bolts depending on your use case. 1 M4x30mm bolt and M4 nut was used to connect the two arm pieces together. (M4x25mm might just be long enough also) To play it safe use 3 M4x30mm bolts.

The monitor I have is 27'', so for a smaller monitor it might be too far away from the screen. The phone fits vertically and horizontally. Designed in Siemens NX

The balljoint I used was designed by @HD_Creator. Go check them out. https://www.printables.com/model/370429-generic-lockable-ball-joint/comments/1796821

The print can be used to mount your phone over or under your monitor too but I think its a bit too long. Let me now if you want me to design a shorter version of the arm.

Print instructions: 

I printed most of the parts with 15% infill and 0.3mm layers. The smaller threaded parts were 0.15mm layers. The largest part (filename “1. Magsafe vesa holder”) was rotated 45 degrees in slicer to fit onto the printbed of my Anycubic Mega S (printbed size 210 x 210 x 205mm.)

Hardware needed:

-2    M4x25mm bolts

-1     M4x30mm bolt

-1     M4 nut

-hotglue for securing the charger (if needed)

 

Tagi