Dual PTFE tube guide V3 for Ender 3 V3 KE
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
V3 of the dual tube guide. If you like to print in two colors, this mod will make your life a little bit easier.
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 93
- Wydruki
- 0
- Wyświetlenia
- 1074
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Printing instructions:
0.2 layer h
4 walls
top surface pattern : hilbert curve
normal auto supports
supports on build plate only : yes
10% cubic infill
Seam position : back
You can stop the print to change the filament for the logo. Look that there were no seams inside the tunnels. You can also paint red for supports from under the model where the hole is to save some time.
This version is a little bit chunkier, but prints faster (in less than 90min) and looks better. I designed this in fusion360. Added better quality and bigger creality logo. Tubes should fit perfectly.