ESP32-CAM Vlogging Stick
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Handheld vlogging stick for ESP32-CAM
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 85
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
What if ESP32-CAM module could record a video? Of course it can!
This camera module can capture footage vibes that are likely similar to a retro digital camera. The module itself has no microphone input, therefore it cannot record audio. You may need to record separate audio clips.
Inspired by insta360, so should we call it “Insta32”? (pun intended).
On the third photo shows the real footage from the camera.
Print Settings Suggestions:
- Layer Height: 0.2mm
- Filament: PETG
- infill: 10%
- Perimeters: 3
Hardware Requirements
1. ESP32-CAM with ESP32-CAM-MB
- image: www.randomnerdtutorials.com
2. 3 Pins Toggle Switch
- image: https://www.amazon.com
3. Step Up 1.5-4.2V to 5V DC-DC Boost Conversion Module
- image: https://www.amazon.com
4. Wiring Cable
Wiring diagram
- Connect Positive (+) from battery to switch common pin
- Connect NO pin from the switch to labeled "Vi" terminal on the Boost Converter Module
- Connect Labeled “Vo” terminal on the Boost Converter Module to Positive Micro USB Cable (or 5V on ESP)
- Connect Negative (-) from battery and Negative from USB Cable (or GND on ESP) to middle terminal of the Boost Converter Module
Here you can solder and add AA battery terminals
- image: https://www.rs-online.com/
- If using metal spring terminal on negative side then you can snap off the printed spring out
Assembly
Use st2.2 x 9.5 or similar size self tapping screw for mounting Handle Cover and Handle together
Software and Codes:
- Follow this GitHub Link for coding, setting up camera and recording.
- By the default setting, camera should record after power on.
FYI:
By the calculation of battery life estimation last around 10-16 hours when using AA Battery and no flash usage.
ESP32-CAM power consumption while turn off the flash @ 180mA 5V.
Source: DigiKey
The battery life depending on battery capacity you're using. I would recommend using a rechargeable battery for sustainability, although it's capacity may slightly lower than regular Alkaline Battery.
Alternatives for Power Supply: Power banks sure does the job.