Antweight Horizontal Bar Spinner - Tiger Shark V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is version 2 of the frame and the first foray into 3D printing. You will notice in the video that the weapon is…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 386
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This is version 2 of the frame and the first foray into 3D printing.
You will notice in the video that the weapon is on the top instead of the bottom. It turned out I didn't have wheels large enough to make the robot sit level with the ground. The blade would touch the ground because it was so long. The compromise was to move the weapon to the top which worked out to some extent
Weapon System
Weapon motor I believe at the time I may have had a bigger motor in the robot A2212
Blade Hub
The weapon blade during this event was an 8x2 inch piece of aluminum that can be purchased from any hardware store.
Drive Assembly
Drive Motor - Fingertech Spark
Snap hubs - 0.75" wide
3 inch foam wheels
Print Settings
Printer Brand:
Solidoodle
Printer:
Solidoodle 2 - Base
Doesn't Matter
Supports:
Doesn't Matter
.02mm
Infill:
25%
Filament:
ABS ABS
Category: Robotics