Remixed EVA3 toolhead for Tronxy D01

This is a toolhead based closely on the EVA3

I modeled it to allow for installation on a Tronxy D01 so as not to sacrifice any of the build plate volume.

Components I remodeled from the ground up:

• Cooling horns (to suit a red lizzard K1 hotend)
• Fan channel and mount (to suit a 5015 blower)
• Belt tensioning assembly (thinner, smaller, uses m3 tension screw, offset, new sliding belt clamps, new mounting holes for fan assembly
• Universal holder (made thinner and smaller, remodelled the belt clamp positions and to 6mm belts, adjusted mount position for adxl)
• bearing block mount (new endstop mount holes)
• belt clamps

Original components used (https://main.eva-3d.page/)

• orbiter 2 mount - original
• red lizzard EVA3 mount (https://www.thingiverse.com/thing:6039158) - 328ftw

To suit endstop like this:

https://www.aliexpress.com/item/32817694814.html?spm=a2g0o.order_list.order_list_main.47.5df618025c9KEm

There is additional z clearance available now since this toolhead is shorter than the OEM one - this required the movement of the z axis limit. I made a new mount for the filament sensor, and bowden tube holder that goes on in place of the original extruder motor. These files are also included. 

Note, I have changed the glass bed to a magnetic adhesive sticker and pei spring steel plate, this has also increased available z travel. You may run out of z bed adjustment on your screws if you keep the original glass bed, you would need to remix the z limit mount.