Remixed EVA3 toolhead for Tronxy D01
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I remodeled the EVA3 tool head for use on a tronxy D01
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 38
- Makes
- 0
- Views
- 423
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a toolhead based closely on the EVA3
I modeled it to allow for installation on a Tronxy D01 so as not to sacrifice any of the build plate volume.
Components I remodeled from the ground up:
- Cooling horns (to suit a red lizzard K1 hotend)
- Fan channel and mount (to suit a 5015 blower)
- Belt tensioning assembly (thinner, smaller, uses m3 tension screw, offset, new sliding belt clamps, new mounting holes for fan assembly
- Universal holder (made thinner and smaller, remodelled the belt clamp positions and to 6mm belts, adjusted mount position for adxl)
- bearing block mount (new endstop mount holes)
- belt clamps
Original components used (https://main.eva-3d.page/)
- orbiter 2 mount - original
- red lizzard EVA3 mount (https://www.thingiverse.com/thing:6039158) - 328ftw
To suit endstop like this:
There is additional z clearance available now since this toolhead is shorter than the OEM one - this required the movement of the z axis limit. I made a new mount for the filament sensor, and bowden tube holder that goes on in place of the original extruder motor. These files are also included.
Note, I have changed the glass bed to a magnetic adhesive sticker and pei spring steel plate, this has also increased available z travel. You may run out of z bed adjustment on your screws if you keep the original glass bed, you would need to remix the z limit mount.