BMW K1200 Brake Fluid Funnel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bleed funnel for BMW Servo Brakes
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 223
- Wydruki
- 0
- Wyświetlenia
- 1199
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
A simple tool designed for a friend, to help bleed your brakes on BMW servo bikes.
BMW charges an unbelievable amount for these funnels so this will save you significantly. Replaces the OEM part number #341580
Should work with R1150R, R1150RS, R1150RT, K1200GT, R1200CL bikes. Also all R1150GS after 9/02, late model (2002 on) R1100S, K1200RS and K1200LT bikes. Also most R1200GS (before 2008), most R1200RT, most R1200ST and most K1200S/R/GT bikes.
Mostly models from 2002-2006 with servo brakes.
Designed with a 19mm nut to allow you to tighten it down, and a standard M18x2.5mm x10mm thread.
This is a tall print, I would recommend a 10mm brim on the outside and slowing the print speeds down to avoid resonance as the funnel gets taller. Will need a 200mm Z-height to print this successfully. The included G-Code is quite conservative and so should work with all printers, it also has the height range modifers that I mention below, added in. You can bump the speeds up if you like.
I would recommend a 0.3mm layer height until the threads where you should drop down to a 0.15mm layer height or lower. You can also drop to a 0.2 or lower layer height on the funnel slope to reduce fluid adhesion through surface tension, and it will also improve print reliability.
PRINT IN PETG ONLY - this is compatible with brake fluid.