BMW K1200 Brake Fluid Funnel
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€4.98 – €6.09 net (excluding VAT)
For file: BMW Bleed Tool v8_0.3mm_PETG_MK3S_6h26m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €5.54 excluding VAT (range midpoint).
- Weight reported by the author
- 54 g
- Print time reported by the author
- 6.44 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Bleed funnel for BMW Servo Brakes
- Rating
- 5 / 5
- Likes
- 10
- Downloads
- 226
- Makes
- 0
- Views
- 1,202
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
A simple tool designed for a friend, to help bleed your brakes on BMW servo bikes.
BMW charges an unbelievable amount for these funnels so this will save you significantly. Replaces the OEM part number #341580
Should work with R1150R, R1150RS, R1150RT, K1200GT, R1200CL bikes. Also all R1150GS after 9/02, late model (2002 on) R1100S, K1200RS and K1200LT bikes. Also most R1200GS (before 2008), most R1200RT, most R1200ST and most K1200S/R/GT bikes.
Mostly models from 2002-2006 with servo brakes.
Designed with a 19mm nut to allow you to tighten it down, and a standard M18x2.5mm x10mm thread.
This is a tall print, I would recommend a 10mm brim on the outside and slowing the print speeds down to avoid resonance as the funnel gets taller. Will need a 200mm Z-height to print this successfully. The included G-Code is quite conservative and so should work with all printers, it also has the height range modifers that I mention below, added in. You can bump the speeds up if you like.
I would recommend a 0.3mm layer height until the threads where you should drop down to a 0.15mm layer height or lower. You can also drop to a 0.2 or lower layer height on the funnel slope to reduce fluid adhesion through surface tension, and it will also improve print reliability.
PRINT IN PETG ONLY - this is compatible with brake fluid.