Kaiweets ST600Y holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for Kaiweets ST600Y multimeter.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 102
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My Kaiweets ST600Y has become my go-to handheld multimeter, so I keep it close at hand in this holder that holds securely but allows virtually effortless removal and replacement. This holder is sized just right to allow the meter to slip in and out quickly, while constraining it from tilting, sliding or twisting out while stored. It features 2 counterbored holes for 4 mm buttonhead screws for attachment to your bench.
I printed my holder with a Sovol SV06 on the stock PEI powder coat plate. I used the Prusa slicer with SV06 profile and printed in durable PETG with the following key settings and conditions:
- 0.20 mm layer height
- 3 perimeters
- Cubic infill at 20%
- No supports or brim
- Glue stick
- Filament: Overture PETG
I had no issues printing mine in an upright orientation with no brim, but you may want to add a brim.
Updated 5/26/2024: Added 1 mm chamfer to front edge of bottom to prevent probe strain reliefs from catching.