Deception Replacement Box and Insert
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A fully printable hinged box for Deception, fits unsleeved expansion.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 39
- Wydruki
- 1
- Wyświetlenia
- 468
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
1-29-25 Edit: One person reported their bullets were too tight, increased size of holes to 13mm.
I bought a secondhand copy of Deception and the box was trashed and dirty, so I bought the expansion hoping it could fit. I actually did make it fit in the expansion box with a ton of lid lift, but have been planning a full 3D printed box for a while.
Sleeved role cards, unsleeved Means/Clues. You might be able to fit sleeved base game cards, but I haven't tried it. Box is roughly 7" square, 175mm.
Multicolor and single color versions available. Needs 4 x (8x3mm) magnets.
Print one top and one bottom as oriented, flat sides down. Align the hinge and put a scrap piece of filament through the hole. Leave 1-2mm on each side and use a heat source to melt the ends and press flat against a hard surface.
Carefully insert the magnets in the right orientation. Print my Magic Magnet Tool first so you don't mess up the polarity.
Happy Gaming!
---------------
If you love board games check out my 100+ free designs here on Printables! Or inserts available for purchase on Printables. And check out all the designs for sale at my Etsy shop Taylor Jane Design Co.