Bowden tube compression fitting (tapered) for Titan Extruder/FLSun Q5
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A compression fitting to replace the the Q5's stock 'Titan' extruder pneumatic bowden coupler assembly
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 358
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
A complete replacement for the Q5's stock bowden pneumatic coupler assembly.
After noticing my pneumatic coupler wasn't holding the bowden tube in place anymore, I designed this compression fitting, taking a lot of ideas from from a few other compression fittings I came across.
Once this is fitted it should feel completely snug, no play on either side!
STL, STEP and FCSTD files attached (for V2)
Print Settings
Printer Brand:
Flsun
Printer:
Flsun Q5
Rafts:
No
Supports:
Yes
Resolution:
0.4mm
Infill:
100
Filament: Jayo PLA
Notes:
Print nut upside down, so that the narrower hole is on the print bed - just to reduce the overhangs.
PETG grips the bowden tubes more tightly due to its more flexible nature, and is recommended if this is intended as a permanent solution. PLA will work just fine in a pinch, but do expect to need to occasionally re-tighten the nut every few prints or so
Slicer Settings
I printed the nut upside down on the print bed (the side with the narrower hole circumference flat on the bed) so there are minimal overhangs.
100% infill is suggested for both parts for increased strength.
Category: 3D Printer Parts
Imported from Thingiverse