Suzuki Jimny (2019+ / JB74 3-door) Dash Mount for Quad Lock
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount suitable to bolt into the little bolt holes within the dash, to mount a 4-hole quad lock base.
- Ocena
- 0 / 5
- Polubienia
- 33
- Pobrania
- 309
- Wydruki
- 0
- Wyświetlenia
- 2378
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Please read the following warning before downloading:
This print could pose a hazard in an accident. It introduces a hard-plastic object into an area where you or your passengers may come into contact during adverse events. My Jimny has an airbag installed, so I've made sure other accessories bolted to this aren't likely to hinder operation of the airbag, and I would recommend you do the same, but there's still always a chance this print could end up hurting someone. Use at your own risk.
With that out of the way…
I wanted to use the standard mounting holes within the Jimny dash to mount my phone. I figured it'd be cool to set it up like this, even though Android Auto works pretty well (but I realise not everyone has that in their spec!).
Had to go through a few versions to get the angles right. I don't think this is a perfect fit by any means, but it's pretty close. The mounting hole in the dash seems to be off perpendicular by about 5 degrees. A single M8 x 25mm socket head cap screw is recommended for bolting this into the dash.
Specifically, I wanted to use the 4-hole rectangular base which Quad Lock sell, so the mounting surface is shaped specifically to match that. If you want to do the same, you'll need four M5 x 12mm countersunk screws to attach it to the print. If you're making your own mounting interface though, using button top, socket head cap screw, or other non-countersunk type fasteners, I wouldn't exceed maybe 8mm in length. I've attached a screenshot of that interface if you want to design your own.
I printed in PETG (with supports from base) and it seems to be okay so far, but I'm expecting some difficulties when summer rolls around again here in Australia. We'll see how we go. Definitely wouldn't suggest PLA for this one. ASA would probably be best?