Pool Overflow Port - Simple Raise or lower water level
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A friend had an issue where his overflow drain was too low. This adds a snorkel piece to replace the original screen.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 230
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Share Alike
Threads are correct for NPT Pipe threads common in pool plumbing. If mounted with snorkel straight up it will raise the water level by about 1 ½ inches. You can adjust pool level by angling the snorkel to the side when tightened. Uses original plug o-ring and recommended to use Teflon tape on threads.
The additional snorkel cap was added later specific to his application. (overflow was under a small waterfall), to protect from loosing water from splash back.
Printed in PETG
0.2 layer height in a 0.4 nozzle
20% infill
Prints threads to build plate as shown. I used Organic supports on build plate only for any overhand over 25 degrees.