Pool Overflow Port - Simple Raise or lower water level
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A friend had an issue where his overflow drain was too low. This adds a snorkel piece to replace the original screen.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 20
- Makes
- 0
- Views
- 230
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Share Alike
Threads are correct for NPT Pipe threads common in pool plumbing. If mounted with snorkel straight up it will raise the water level by about 1 ½ inches. You can adjust pool level by angling the snorkel to the side when tightened. Uses original plug o-ring and recommended to use Teflon tape on threads.
The additional snorkel cap was added later specific to his application. (overflow was under a small waterfall), to protect from loosing water from splash back.
Printed in PETG
0.2 layer height in a 0.4 nozzle
20% infill
Prints threads to build plate as shown. I used Organic supports on build plate only for any overhand over 25 degrees.