Feed Neck for Spyder MR1 Paintball Gun
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Feed neck for the Spyder MR1 paintball gun
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 170
- Wydruki
- 0
- Wyświetlenia
- 756
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This is a 45-degree offset feed neck to replace the clear plastic one that comes with the Spyder MR1 paintball gun. It's designed to use the old bolts and nuts, but if you don't have those, you can use 8-32 machine screws and nuts instead. The smaller opening where it connects to the gun is 7/8" or 22mm. The larger opening where it connects to the hopper is 1 1/32" or 26.5mm.
The one shown in the picture was printed in Bambu PLA Tough, which is flexible and has excellent layer adhesion. I would recommend using something with similar properties, such as a good quality PETG. There are a couple areas that need supports.