Ultimaker 2, Go, Extended ELP Camera Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
ELP Camera mount to fit on the side of a Ultimaker 2 Go
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 175
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This was a design I threw together after not being able to find a simple camera mount for an ELP Camera for the Ultimaker family. Since the 3's and up have cameras built into them, this was only designed to fit onto the Ultimaker Go's and the Ultimaker 2's
This piece should be printed with brims to help with warping, as well as with supports on the cavity on the bigger piece. I found that the gap in the brace on the bigger piece did not need supports so to save time and frustration cleaning it up I decided to use support blockers when I printed them.
Camera used: https://www.amazon.com/ELP-megapixel-Camera-Module-45degree/dp/B01DRJX8JU
This was designed to fit most cameras that do not need a 2nd connector for power
Time-lapse Print using this mount to hold a camera: