Denver SCO-65220 rear fender mudguard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement without breaking possibility.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 203
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Share Alike
My friend needed a new fender, but there was nothing available. Fortunately, I found the XEKs model, and as he shared also the F3D file, I was able to quickly adapt to the 6.5" wheel model.
There is a quite small clearance between the fender and the wheel, but I hope it will be okay.
I've printed it with A LOT of perimeters, almost solid, so with an emergency breaking, it should still last for some time. I've also added some helper discs at the end instead of the brim.
Printed in PETG. ABS/ASA would be fine too, but I don't think PLA would be a good option here.
Warning: You will need longer screws! The original is M4x25 but you will need M4x30. While you are buying those, take a pair of nylock nuts too 😉