Fujitsu D2607 fan mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A cooler mount for the Fujitsu D2607 raid card. It fits 40x40 mm fans of any depth.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 198
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A fan mount for the Fujitsu D2607. It fits 40x40 mm fans of any depth. This design is only suitable for use in systems where the Fujitsu D2607 is mounted “normally”, like in common consumer cases, due to gravity holding it in place.
I printed it with recycled PLA and it works great so far! I also used organic supports which I recommend.
To mount this cooler you need to firstly screw in the fan. The fan should be oriented with the backside against the heatsink for correct airflow direction. Then you can just slide on the cooler and lift it over the heatsink fasteners.