1 / 5
Avocado Seed Starter 2
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It has an in-built stand for the seed, and drainage holes into the water holder. Can transfer out when it grows.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 289
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (12)Powiązane
Standard PLA+ settings.
I printed with 0.3mm first layer and 0.2mm layers after, 5 perimeters, 6 (Top) and 5 (Bottom) horizontal layers, extra perimeters if needed turned on, random seam position with fill gaps checked on, 60% gyroid infill, 30% infill/perimeter overlap, and 2C over typical print temperature (for me that was 230C for PLA+ when typically I print at 228C for my printer). No supports needed.