1 / 3
Creality Ender V3 KE Filament Run Out Sensor Side Relocation — zdjęcie 1
1 / 3

Creality Ender V3 KE Filament Run Out Sensor Side Relocation

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Bracket to allow side mounting the filament runout sensor on the Creality Ender V3 KE.

Ocena
0 / 5
Polubienia
38
Pobrania
227
Wydruki
1
Wyświetlenia
1997
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This bracket allows side mounting the filament runout sensor on a Creality Ender V3 KE. I produced it because I was concerned there was too much friction when I had the run out sensor mounted on the Side Spool Mounting design presented here: https://www.printables.com/model/723074-ender-3-v3-ke-side-spool-mounting

It is necessary to extend the runout sensor cable which could be done using a 3 Pin JST 2.54 extension cable, or by cutting and soldering the existing cable. I routed the extended cable under the top of the gantry with electrical tape.

Suggested print orientation is with the part of the bracket which will be fitted facing the rear of the printer flat on the bed. I used tree supports.