1 / 3
Creality Ender V3 KE Filament Run Out Sensor Side Relocation — image 1
1 / 3

Creality Ender V3 KE Filament Run Out Sensor Side Relocation

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Bracket to allow side mounting the filament runout sensor on the Creality Ender V3 KE.

Rating
0 / 5
Likes
38
Downloads
227
Makes
1
Views
1,997
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

This bracket allows side mounting the filament runout sensor on a Creality Ender V3 KE. I produced it because I was concerned there was too much friction when I had the run out sensor mounted on the Side Spool Mounting design presented here: https://www.printables.com/model/723074-ender-3-v3-ke-side-spool-mounting

It is necessary to extend the runout sensor cable which could be done using a 3 Pin JST 2.54 extension cable, or by cutting and soldering the existing cable. I routed the extended cable under the top of the gantry with electrical tape.

Suggested print orientation is with the part of the bracket which will be fitted facing the rear of the printer flat on the bed. I used tree supports.