Air Quailty Monitor Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple case to house the AQI Monitor that I made
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 663
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
I designed and build a small air quality monitor based around an ESP32 using an ENS160, Grove Dust Sensor, and AHT20 to collect data.
I made a video about it! Check it out here:
I also wrote up an Instructable about the project here: https://www.instructables.com/Air-Quality-Monitor-2/
I even figured out how to use GitHub (kinda): https://github.com/tinyboatproductions/AQI-Sensor/
If you would like to support me: https://ko-fi.com/tinyboatproductions
I needed a case to house everything and make it portable. That's this.
This case has mounting locations for all of the sensors and parts I used.
I printed this out of ASA as I plan to use it in my printer enclosure which can get pretty toasty, but any filament should work.
All of these parts should be easy to orient on the build plate. When In doubt, the STLs are correctly oriented.
The only part that needs special attention is the grate. I printed it with 15% honeycomb infill and 0 top and bottom layers. this will give you just the infill. It will allow a lot of air through while keeping fingers and other objects out.