Delta-V Dual v4.3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
higher flow and higher visibility version of the Delta-V 3.2
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 72
- Wydruki
- 2
- Wyświetlenia
- 449
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- GNU General Public License v3.0
Upgrade from v3.2 to v4.3:
Needed prints: Delta-V Dual v4.3.stl
Printing: I used my 0.25 speed profile in PETG with good results, but i would recommend standard 0.2 prusa profiles!
Needed Tools: 2.5mm allen key.
Assembly: remove the 2 mounting screws for the v3.2 and swap in the v4.3. its that easy!
-Fresh install-:
Needed prints: Delta-V Dual v4.3.stl, 7mm bushings (2).stl, V2R2.2 cover.stl
Needed hardware: 2x m3x40 screws (normally used in extruder assembly), 2x Prusa 5015 5v 3pin blowers, 3x M3 hex nuts, 1x M3 square nut
Printing: I used my 0.25 speed profile in PETG with good results, but i would recommend following the original print spec for the Delta P.
Needed Tools: 2.5mm allen key, soldering iron, wire strippers, clean and steady hands.
Wiring Rear Fan: Wired proper through the harness.
Wiring Front Fan: The outer fan has about 6" of wire length (looped behind the PINDA wire loop) and the ends are soldered to the first fan which you can find after removing the rear sticker. ONLY the black and red wires are soldered into the first fans contacts with their respective colors, and the PWM signal wire(white or yellow) is cut 1" shorter and not used. The RAMBO board can only read one PWM signal at once. Using the second white wire will cause errors.
Assembly: Disassembly and Cover instructions from the original Delta P are the same except for the last step. Instead of one fan, its two and the 2x 7mm spacers are meant to be placed in between the two fans at each mount hole.