BB Weight Dial for Odin M12 Sidewinder Speedloader
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
BB Weight Indicator Dial for the Odin M12 Sidewinder or similar speedloaders, or other BB "containers"
- Ocena
- 5 / 5
- Polubienia
- 16
- Pobrania
- 80
- Wydruki
- 1
- Wyświetlenia
- 954
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Attaches to the speedloader with glue, so it is (depending on the glue) a rather permanent solution. You can potentially use strong double-sided adhesive instead.
Add glue on the back in the groove at and at the outer edges, away from the center dial so it is not glued in place and free to rotate.
Before you attach it to your speedloader please ensure there's the right amount of friction between the two pieces when pressed firmly together (the smaller piece is 0.20mm thinner).
It might be necessary to use a sharp knife around the edges of the smaller piece to scrape off a wee bit of material depending on the exact print settings, but don't overdo it as some friction is necessary to keep the arrow pointing where you left it.
It's Ø54mm and 2.4mm thick. Includes 2 rings/dials, one with 0.12g to 0.43g and another with 0.30g to 0.48g.
3D printing settings
Print upside-down as seen on one of the pictures and consider adding a color swap at 0.80mm (so the first 0.60mm are one color and the rest another color).
I used 0.20mm layer height, a 0.40mm nozzle and 100% infill. Uses 5g filament and took 29 minutes to print on my stock MK3S.
Can be printed in tacticool colours too!