40oz Kratky Hydroponic Pot with Water Level Indicator
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 40oz pot for kratky hydroponics. It uses a 2in net pot & piece of 1/4 inch id tubing for a water level sight.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 648
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a pot i could see the water level without letting a lot of light in. This works out cheaper and better than mason jars. It only requires a small piece(13cm) of ¼ inch id tubing, for the water level indicator, and a 2 inch or 50mm net pot.
The original version has marks from 8oz to 36oz in 4oz increments, v2 has marks from 8oz to 28oz in 4 oz increments. The reason for v2 is because 28oz is just enough water/nutrients to barely touch the bottom of the net pot,which is the fullest it should ever need to be. After roots develop you will not want to fill it as full. One trick is to add about 1tsp per gallon of 3% hydrogen peroxide to your water to help aerate the roots. I also find a little super thrive really helps new roots get started at the beginning.
I prefer the stiffer ¼" tubing and then I heat it up before pressing it on the bottom for a water tight fit. If you use more flexible tubing you may or may not need a zip tie to help it seal. The hose barb on the container is .5mm over ¼" for a firm press fit in most cases. If it is too tight try wetting the inside of the tubing or use a little heat on the tube. The barb on the lid is smaller for easy removal.
The lid works out as a friction fit for me on multiple printers so should be good for you too. If the lid is too tight try slightly scaling it up in slicer.
I advise printing hot and slow for the best water tight results. .28mm to .3mm layers will help with print time, or even better a larger nozzle. None of mine have leaked so far at max of 80mms.
The lid will need flipped 180 in your slicer. No supports are needed.
Use whatever filament you are comfortable with. PLA is water tight for me without any extra sealing. I am not sure how it holds up over a very long time yet. PETG may be better for longevity, especially outdoors or in a sunny window. I will update how the PLA holds up in the future.
Enjoy and happy growing!