1 / 2
Shearwater 125 Turning Handle Bearing Sleeve — zdjęcie 1
1 / 2

Shearwater 125 Turning Handle Bearing Sleeve

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Sleeve for a 605-2RS bearing to be pressed into the Shearwater 125 steering handle. Used to stop backing the screw out

Ocena
0 / 5
Polubienia
3
Pobrania
14
Wydruki
0
Wyświetlenia
146
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The Shearwater 125 steering handle keeps pulling the screw out at the worst times. I have installed a 605-2RS (5mm ID, 14mm OD) bearing (from Amazon) and made this sleeve for the bearing to let the handle move independently of the screw. Just get a M5 screw that is 5mm longer in order to install (25mm instead of 20mm). Use thread locker on the screw

Printed in PETG, but most anything would probably be fine. This won't see a lot of load.

Tagi