Vidroc SQ11 Camera Mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
Vidroc SQ11 camera mount
Update - Added a BT-50 nose cone mod for this camera. - You have to print the nose cone with supports. - Either glue or screw the camera mount into the notch in the nose cone Simple set of mounts that allow you to mount a SQ11 onto your airframe using either nylon straps or a countersink screw. The SQ11 is a remarkably small 1080p camera - a little of a pain to activate but once you get used to it, it's not so bad. (did I mention these are CHEAP, too?) The camera fits in VERY firmly but I included a small hole for a tiny set screw if you need to secure it more. (My prints are so firm I have to use a small flat tip screwdriver to pop the camera out) There is a small custom support you need to cut out after printing. If you use this post you videos in the comments!! Here is the Fusion 360 file Vidroc SQ11
Category: Hobby