Cineroc 4k (and then some)

Made to work with the Matecam 4k WiFi module -

This was designed for the 4K Camera Pinhole Cam Mini DIY Full HD 1080P WIFI Camera with Motion Detection Audio Recorder 4K PCBA - 4 years ago.  The newer one may not properly fit the newer version of this configuration. 

https://www.amazon.com/gp/product/B077BLJDXG/ref=oh\_aui\_detailpage\_o00\_s00?ie=UTF8&psc=1

Heat sinks I use to help keep the PC board cooler

Easycargo 15 pcs Raspberry Pi Heatsink Kit Aluminum + Copper + 3M 8810 thermal conductive adhesive tape for cooling cooler Raspberry Pi 3 B+, Pi 3 B, Pi 2, Pi Model B+

Post-Printing

Build notes

The PC board goes onto the sled with the SD card on the left (with camera saddle pointing away from you). The camera cable will flip 180 degrees when the camera is mounted.

The camera should just snap into the saddle but if it's too loose (different printers can yield different fits) use some tape to help secure it. (I may update this part as testing continues)

Use leftover filament to hold the PC board in place - you should be able to see the available holes for this in the sled.

You really should get some Raspberry Pi heat sinks to help keep the PC board cooler.

This is what I used - Easycargo 15 pcs Raspberry Pi Heatsink Kit Aluminum + Copper + 3M 8810 thermal conductive adhesive tape for cooling cooler Raspberry Pi 3 B+, Pi 3 B, Pi 2, Pi Model B+

https://www.amazon.com/gp/product/B07217N5LS/ref=oh\_aui\_detailpage\_o06\_s00?ie=UTF8&psc=1

The battery clip CA glues to the base of the camera sled and you zip tie the battery to that.

It's important when gluing the battery clip on that you leave room for the camera sled to fit into the base.

The WiFi antenna just hangs (for now) - it does have a double stick tape on it so you could stick it to the back of the battery clip.

Category: Hobby